IEC mains lead, mains plug country dependent

RC20 remote control transmitter

Battery for RC20

Receiver whip antenna for remote control

Screwdriver, for replacing mains fuse
and battery of RC20

Right angle BNC adapter for antenna, when
using the Amphion in horizontal position

CA20 output adapter cable for headphone. Cable socket type on demand.

• Default type: 3.5 mm Jack socket (headphone elements connected in series, ground not connected)
• 3.5 mm Jack socket (headphone elements connected in parallel)
• 6.3 mm Jack socket (headphone elements connected in series, ground not connected)
• 6.3 mm Jack socket (headphone elements connected in parallel)

FC20 flight case, shown with Amphion and standard accessories

CA21 Speakon splitting cable assembly for dual loudspeaker connection. Cable socket type on demand.

• Default type: two 4-pole Speakon cable sockets (pins 2+ and 2- of which are not connected)

• Two mono 6.3 mm Jack sockets

CA06 attenuator cable assembly to attenuate the input signal or increase the input impedance. To be connected directly to the line input. Cable type on demand.

Examples:

• Default type: Phono socket, attenuation: -10 dB (input impedance: 58.7 kΩ), length: 15 cm

• Phono socket, attenuation: -20 dB (input impedance: 183.5 kΩ), length 20 cm

CA05 transformer adapter, to insulate the line input ground from the line output ground or to connect the Amphion to a balanced signal device. Adapter type on demand.

• Default type: trafo Neutrik NTE1, balanced female XLR (input)

• Trafo Neutrik NTE1, balanced male XLR (output)